LockState LS-RDJ Manual

The LS-RDJ comes standard with the
following features:
1 unique master code
•
9 unique user codes
•
Low Battery Alarm
•
External power capability
•
Manual override keys
•
Tamper-proof error function
•
Easy installation
•
1. INSTALLATION
1.1 Lock Diagram
Below is a diagram of the LS-RDJ with
numbers indicating areas of function. These
numbers correspond with their description in
the box below:
1
Handle (Left handle or Right handle)
2
"S" key (setup key) for setting new codes
3
Green light indicating the lock is open
4
Socket for external power (6V)
5
Red light indicating the lock is not open
6
Digital keypad (digits 0-9)
7
"ON" key used for unlocking the lock
8
Emergency manual keys
Fig. 1
1.2 Door Diagram
If you are installing the LS-RDJ in a
door with pre-drilled holes, the lock
will fit most standard doors. To
confirm that the lock will fit your door,
please verify the following
measurements:
1. Backset is either 2 3/4" or 2 3/8"
(backset is the measure from the edge of
the door to the center of the knob hole)
2. Door knob hole is 2 1/8"
3. Latch Hole is 7/8"
(see figure below)
1.3 Installing the Batteries
The battery case is located in the lower
half of the outside lock piece.
Remove the battery case by inserting
the small green screw driver through
the bottom hole of the back side of
the front mount (see below). As you
press the screw driver through the
hole the case will release from the
bottom of the mount. Place 4 AA
batteries in the case and replace the
case in the mount.