LockState RemoteLock 6i Installation Manual

www.RemoteLock.com
Installation Manual
Major Parts List
1 2 3 4 5 6 7 8 9 10 11
1 - Inside Lever 7
- Sprindle
2 - Battery Housing Cover
8 - Outside / Front Gasket
3 - Inside / Back Lock Housing
9 - Outside / Front Lock Housing
4 - Inside / Back Mounting Plate
10 - Indicator Light
5
- Inside Gasket 11 - Key Override Cylinder
6
- Latch 12
- Outside Lever
Installation Instructions
1 2 3 4
Insert latch Drill the 3/8" Place the Insert the
into the door upper support front side square
latch hole. hole into the rubber gasket spindle into
Secure the door 3 " (if required) the center
5/16
latch with two above the on the back of hub. Ensure
screws. center of the front lock dot is pointed
boring hole. housing. left.
5 6
Fit the front lock housing onto the Place the inside gasket on the inside
front of the door. Feed the power plate. Feed the power plug through
plug through the door hole. and secure the plate to door & front
lock with 3 screws.
12
7 8
Hold the inside lock housing up to the Place inside
inside of the door. Plug the front lock lock over
power cable into the connector on the mounting plate
back. & secure with
screws.
10 11
Secure the inside lock housing Slide the inside lever into place.
battery cover with two screws. Press firmly undil the handle snaps
over the catch pins.
Front Handle Installation
1
Ensure that the key override slot is in
the horizontal position.
9
Insert 4AA
batteries in to 3
Insert the key into the key cylinder
the battery
from the front of the handle.
compartment.
5
Push the key in as far as it will go and
then turn 90 degrees clockwise.
2
Slide the key cylinder into the back of
the handle.
4
Slide the handle onto the drive shaft
until it hits the catch pins.
6
Firmly press the lever until it snaps
over the catch pins. Turn the key back
to the left and remove.