Dolmar TM-98.14 H2D Operator's Manual page 112

EN 14
4.5 L
IGHT SWITCH
For turning on the lights when the key (4.3) is in the «ON» position.
4.6 P
ILOT LAMP
This lamp comes on when the key (6) is in the "ON" position and stays on while
the machine is running.
– When it flashes, it means that it is not ready for starting (☛ 5.2).
4.7 B
LADE ENGAGEMENT AND BRAKE CONTROL
The lever has two positions, as shown on the label:
«A»= Blades disengaged
«B»= Blades engaged
– If the blades are engaged when safety conditions have not been complied
with, the engine shuts down and cannot be restarted (☛ 5.2).
– On disengaging the blades (Pos. «A»), a brake is simultaneously activated
which stops their rotation in a few seconds.
4.8 C
UTTING HEIGHT ADJUSTING LEVER
There are seven positions for this lever, shown as «1» to «7» on the label, which
correspond to various heights between 3 and 8 cm.
– To go from one height to another, press the release button at the end of the
lever.
➤
For mechanical drive models:
4.21 C
LUTCH
This pedal has a double function: during the first part of its travel it acts as a
clutch, engaging and disengaging drive to the wheels, and in the second part
it acts as a brake on the rear wheels
IMPORTANT
➤
( if fitted)
/ B
RAKE PEDAL
Do not keep the pedal half way between clutch engage-
CONTROLS AND INSTRUMENTS