Gardena 1242 Series Operating Instructions Manual page 7

7. (a)
7. (b)
Changing an existing
watering programme :
Ending the programming
mode early :
Reset :
18
7. (a) Watering cycle every 2nd or 3rd day :
Set the arrow ê to 2nd or 3rd using the ▲-▼ keys
(for example 3rd = every 3rd day) and confirm by pressing
the Ok key.
The watering programme is saved. The watering cycle
(for example 3rd ) and the preview for the week (for example
Mo, Th, Su ) are displayed for 2 seconds. The display then
returns to point 1 and the next programme flashes.
The days in the preview for the week always depend on
the current day of the week.
– or –
(b) Watering cycle for any day of the week :
Set the arrow ê to the correct day (for example Mo = Monday)
using the ▲-▼ keys and activate or deactivate each day by
pressing the Ok key.
Once you have activated all the days on which you require
watering (for example Mo, We, Fr), press the ▲ key repeatedly
until the arrow ê over Su disappears.
The watering programme is saved. The watering cycle
(for example Mo, We, Fr ) is displayed for 2 seconds.
The display then returns to point 1 and the next programme
flashes.
If a watering programme already exists for one of the 6 pro-
grammes, you can change the data for this programme without
having to re-enter the entire programme.
The values for the watering start time, watering time, and water-
ing cycle already exist. You therefore only have to change the
specific data you wish to change. All other values can be accepted
in the "Creating Watering Programme" mode by simply pressing
the Ok key.
You can exit the programming mode prematurely at any time.
v Press the Menu key. The main level (time and day) is displayed.
The Programming Unit is reset to the basic state and all
programme data is deleted.
v Press the ▲ key and the Ok key simultaneously and hold down
for 2 seconds.
• All symbols on the display are shown for 2 seconds.
• The programme data for all programmes is deleted.
• The manual running time is set to 30 minutes (
• The system time and day are not deleted.
You can reset the Programming Unit by pressing the ▲ key and
the Ok key from all programming levels. The display then shows
the main level.
0 : 30
).