Operation - Makita DUB363 Instruction Manual

Cruise control function
The cruise control function allows the operator to main-
tain a constant speed without pulling the trigger. To
increase the speed, turn the control lever forward. To
decrease the speed, turn the control lever backward.
1
► 1. Control lever
Hex wrench storage
When not in use, store the hex wrench as illustrated to
keep it from being lost.
► 1. Hex wrench
Accidental re-start preventive
function
If you turn on the machine while pulling the switch trig-
ger or while the control lever is not in the off position,
the machine does not start. To start the machine, first
release the switch trigger and return the control lever
fully, and then turn on the machine.
Electronic function
The machine is equipped with the electronic function for
easy operation.
• Constant speed control
The speed control function provides the constant
rotation speed regardless of load conditions.
Hold the machine firmly with a hand and perform the
blowing operation by moving it around slowly. When blow-
ing around building, big stone or vehicle, direct the nozzle
away from them. When performing an operation in a
corner, start from the corner and then move to wide area.
1
11 ENGLISH

OPERATION

CAUTION:
Do not place the machine on the
ground while it is switched on. Sand or dust may enter
from suction inlet and cause a malfunction or personal injury.
Blower operation
CAUTION:
When performing the blower opera-
tion, be sure to remove the suction pipe, suction noz-
zle, elbow pipe and dust bag from the machine, and
attach the blower pipe and nozzles to the machine.
Vacuuming operation
CAUTION:
When performing the vacuuming
operation, be sure to remove the blower pipe and
nozzles from the machine, and attach the suction
pipe, suction nozzle, elbow pipe, dust bag, and
shoulder strap to the machine.
CAUTION:
Check the dust bag frequently for
wear or deterioration.
CAUTION:
Be sure to fasten the fastener of
the dust bag before operating the machine.
CAUTION:
Always switch off the machine before
opening or fastening the fastener of the dust bag.
NOTICE:
Do not allow wet materials, such as
wet leaves, and foreign materials, such as large
wood chips, metals, glass, pebbles, etc., to be
sucked into the machine. Otherwise, a malfunction
may occur.
NOTICE:
Empty the dust bag before it becomes
full. Otherwise, a malfunction may occur.
NOTICE:
To prevent the suction of foreign mate-
rials, operating the machine in the vacuuming
mode is recommended.