Siemens AP-220-MNT-W3 Installation Manual page 2

2. Tape the AP-220-MNT-W3 Drill Template to the desired location and drill holes where indicated by the
template.
3. Once the holes have been drilled, remove the drill template and position the mounting bracket flat
against the surface. Align the holes of the mounting bracket with the pre drilled holes, then screw the
housing into place.
Screws for
4. Press the RJ45 coupler(s) into the housing(s) located in the upper corner(s) of the mounting bracket
until locked into place in the housing(s), as shown in
Figure 2 Attaching the RJ45 couplers to the mount
5. Remove the RJ45 cable(s) from the bag and insert the end(s) into the inner-facing port(s) of the
couplers. See
Figure 3 Inserting the RJ45 cables into the coupler
6. Connect the opposite end(s) of the RJ45 cable(s) to the ENET0 and/or ENET1 port(s), located on the
back of the access point.
2
step 3 are not included in this kit and may vary depending on the surface type.
Figure 3.
Figure 2.
AP-220-MNT-W3 | Installation Guide