Metal Distortion Pedal
Main Features
3 Working Modes: Lo Boost/Boost Off/Hi Boost
Full metal shell
Very small and exquisite
True bypass
DC 9V Adapter power supply
Lo Boost: Boost a narrow band of high frequencies a little bit.
Boost Off: No boost is engaged.
Hi Boost: A higher amount of boost is engaged.
3
6
7
8
TONE
9
4
5
6. Mode Switch:
Switch between Lo Boost mode, Boost Off mode and Hi Boost mode.
7. VOLUME Knob:
Adjust the volume of the distortion sound.
8. TONE Knob:
Adjust the tone color of the distortion sound.
9. DIST Knob:
Adjust the gain of the distortion sound.
Effects Modes: 3 (Lo Boost, Boost Off, Hi Boost)
Input: 1/4" monaural jack (impedance: 1M
Output: 1/4" monaural jack (impedance: 470 Ohms)
Power Requirements: AC adapter 9V DC (center minus plug)
Current Draw: 20 mA
Dimensions: 93.5mm (D) × 42mm (W) × 52mm (H)
Weight: 160g
Accessories: Owner's Manual
*
Disclaimer: Any specification's update won't be amended in this manual.
1. TRUE BYPASS
Footswitch:
Push down the footswitch
to switch between effects
and bypass status.
2. ON/OFF LED:
Instructs effects or bypass
status of BLADE, when the
LED is lit up, the effects is on.
3. DC IN Power Jack:
For power supply, use a 9-volt
DC regulated AC adapter(plug
polarity is positive on the barrel
and negative in the center).
4. INPUT Jack:
1/4" mono audio jack, for
connecting guitar.
5. OUTPUT Jack:
1/4" mono audio jack, outputs
the signal.
Ohms
)