Assembly - Gardena EasyClean Li Operator's Manual

Only charge and use the battery product in ambient tem-
peratures of between 0 °C and 40 °C. Allow battery to
cool down after long periods of use.
Check the charging cable regularly for signs of damage or
ageing (brittleness). Only use it in perfect condition.
Do not stow or transport the battery product above 45 °C
or in direct sunlight. Ideally, the battery product should be
stored below 25 °C so that self-discharge is low.
Do not expose the battery product to rain or wet condi-
tions. Water entering a battery product will increase the
risk of electric shock.
If usage of the battery is not planned for a certain time
(winter period) reload the battery to avoid a deep dis-
charge.
Do not store the battery product in places where static
electricity is present.
Electrical safety
DANGER! Cardiac arrest!
This product makes an electromagnetic field while it
operates. This field may under some conditions
interfere with active or passive medical implants. To
decrease the risk of conditions that can possibly
injure or kill, we recommend persons with medical
implants to speak with their physician and the medi-
cal implant manufacturer before you operate the
product.
Before using the product and after a powerful impact,
check for signs of wear or damage and repair as neces-
sary.
If the product can no longer be switched off in the event
of a defect, place the product on a solid surface and
monitor it until the battery is empty. Send the defective
product to our GARDENA Service Centre.

2. ASSEMBLY

Wait for the engine to stop before you
assemble the product.
To assemble the nozzle [ Fig. A1 ]:
2 nozzles are in the scope of delivery:
– Crevice nozzle, long
– Brush nozzle
To assemble the nozzle:
(1)
v Slide the nozzle into the suction connection
the nozzle is firmly seated.
If required, the brush head can be slid forward at the brush
nozzle.
To remove the nozzle:
(1)
v Remove the nozzle from the suction connection
Never attempt to use an incomplete product or one with
an unauthorised modification.
Do not charge a damaged product. Please contact the
GARDENA service department.
Personal safety
DANGER! Risk of suffocation!
Small parts can be easily swallowed. There is also
a risk that the polybag can suffocate toddlers. Keep
toddlers away when you assemble the product.
Know how to stop the product quickly in an emergency.
Only work in the daylight or when visibility is good.
Check your product before each use. Always visually
inspect your Hedge Trimmer before each use. Check that
the ventilation slots are not obstructed in any way.
If the product got hot while operation, let it cool down
before storage.
Do not overload the product.
Warning! When wearing hearing protection, and due to
the noise produced by the product, the operator may not
notice persons approaching.
Inspect the filter cage for damages before usage.
Do not use the product with a damaged, or without the
filter cage. The filter cage can be ordered through the
GARDENA service.
Do not use the product without the debris container
assembled.
Do not vacuum any hot, or corrosive materials.
Do not vacuum water.
Do not use the product while you are tired or under the
influence of drugs, alcohol or medication. A moment
of inattention while you operate the product may result
in serious personal injury.
To assemble the charging station on the wall
[ Fig. A2 ]:
The charging station is in the scope of delivery with
Art. 9340.
The screws (diameter 3.5 mm) are not in the scope of
delivery. Suitable fixing material is available from your
specialist store.
v Assemble the charging station to the wall by using the
(3)
two holes
If the charging station is mounted on the wall, the nozzle
must be removed to charge the vacuum cleaner (otherwise
(2)
until
the vacuum cleaner will not engage correctly in the charg-
ing station).
The nozzles can be attached to the side of the charging
station.
(2)
.
(hole distance 42.6 mm).
13