Safety Instructions - TdA FBD180 Installation And User Manual

FBD120/180/200/220 SECTIONAL GARAGE DOOR OPENER

1. Safety Instructions

THESE ARE IMPORTANT SAFETY INSTRUCTIONS. FOLLOW ALL INSTRUCTIONS AS
INCORRECT INSTALLATION CAN LEAD TO SEVERE INJURY OR DEATH
The door opener should be installed and put
into operation
Otherwise,
property damage may occur.
Before installation of the door opener, the
door should be carefully checked for being
kept well balance. The door must be in good
working order. Open and close the door
manually, make sure the door can be moved
smoothly.
Installation
compliance with your local building and
electrical codes. Connect the power supply
cord only to properly earthed mains.
No one or vehicle is allowed to enter or leave
the garage while the remoter is being
installed, do not allow children to play near
the door.
The operator may only be repaired with the
door closed.
Failure to comply with the instructions
above may result in personal injury or
property damage. Our company does not
accept responsibility for damage or injury
resulting from installing this operator.
When using auto close mode, a photo electric
beam must be fitted correctly and tested for
operation at regular intervals. Extreme
caution is recommended when using auto
close mode. All safety rules must be
followed.
WARNING: Important safety instructions. It is important for the safety of persons to
follow all instructions. SAVE THESE INSTRUCTIONS.
by qualified personnel.
serious personal injury
and wiring must be
Locate any fixed control: within sight of door
but away from all moving parts of the door
and at a height of more than 1.4m above the
or
ground to avoid children reaching it. Keep
remote controls away from children, to
prevent the door opener from being activated
involuntarily.
The operator should be disconnected from
mains power to avoid electrical shock before
repairing it or opening its cover.
When opening or closing the door, do not
attempt to walk or drive through the door.
in
The door should only be operated when it can
be observed to avoid accidents.
Install and adjust the manual release so
that the handle hangs less than 1.5m
above the floor.
TDA recommend the photo electric beam to
be installed on all garage door openers.
Safety
measure of safety against entrapment and
is strongly recommended for home owners
with young children. Photo electric beam
must be used for all installation where the
closing force as measured on the bottom of
the door is over 400N(40kg). Excessive
force
operation of the Safety Reverse System or
damage the garage door. Installers must
ensure that the doors are installed in a
compliant
60335-2-95.
3
sensor provides an
will interfere with the
manner as per
additional
proper
AS/NZS