Advertisement
2. Tap the button to scroll through the selections. When the yellow LED is blinking,
press and hold the side button until all the LEDs blink (about 5 seconds)
All three LED's will blink on and off quickly for a second followed by a pause, then
repeats. When the sensor receives a range confirmation telegram from the linked
controller, the sensor displays the signal strength status for 2 seconds, see table
below.
LED - blinking
Green
Yellow
Red
None
The test will repeat every 10 seconds and run for a duration of 180 seconds.
Error Codes
When a low battery state has been detected during normal operation, the battery
status is blinked about once per minute. A single red blink indicates the last measured
battery voltage is low. A triple red blink indicates the battery voltage is critically low
(less than 2.0V) and should be replaced immediately.
A stuck button will cause the red LED to blink ~ every 5 seconds.
Equipment Profiles
EEP: F6-04-01
Accessories
PTM365BP1W - Single gang barrier plate for switches - UL and CSA certified
PTM365BP2W - Dual gang barrier plate for switches - UL and CSA certified
FCC Part 15.231 - Remote Control Transmitters
Devices equipped with 902 MHz radio:
Contains FCC ID: SZV-TCM515U
Contains IC: 5713A-TCM515U
The enclosed device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(I.) this device may not cause harmful interference and
(ii.) this device must accept any interference received,
including interference that may cause undesired
operation.
IC RSS-210
Copyright 2019 Echoflex Solutions, Inc. Specifications subject to change without notice.
Echoflex Solutions
38924 Queens Way, Unit #1, Squamish, BC, V8B 0K8, Canada
echoflexsolutions.com
4
Signal Strength
-41 to -70 dBm
-70 to -80 dBm
-80 to -95 dBm
No linked controllers detected. Move sensor closer or add telegram
repeating
Keycard activation switch
For more information on Echoflex Solutions, scan the QR code:
8DC-5896-1.0
Document Part # 8188M21-5896-1 Rev A
n
n
Status
Best
Good
Not ideal, try moving sensor closer
+1 778-733-0111
n
11/19
n
Advertisement
