Advertisement
is on the back of the KSS and slides off as indicated by the arrow.
Before inserting the new battery, press the test button for 10
seconds to discharge any stored energy in the station. Replace
the battery with a CR2032 coin cell. The positive side faces the
slide out battery cover. When a battery is inserted a successful
station start up is indicated by an LED sequence: green -> yellow
-> red repeated three times.
A weak battery will cause a repeating red blink roughly every
half second.
-
blink roughly every 5 seconds.
Test Modes
1. Press the button on the side of the unit (access from
back side) using a small tool.
2. Press and hold the side button until all LEDs blink (about 5 seconds)
3. Tap the button to scroll through the selections. (see table below)
4. To select an item, press and hold the button until all the LEDs blink (about 5
seconds). The LED blink is visible through the keycard plastic (ambient light
may need to be dimmed to view the LED blinks)
Test mode times out after 180 seconds.
Single red blink
Single yellow blink
Single green blink
Single green + red blink
Single green + yellow blink
Reset
When reset, a successful switch start up is indicated by a LED sequence: green -> yellow ->
red repeated three times.
A weak battery will cause a repeating red blink roughly every half second, or a triple red
blink if the battery is critically (less than 2 V). A stuck button will cause a repeating red blink
roughly every 5 seconds
Range Confirmation
Provides visual feedback of the KSS stations signal strength received by a linked
Echoflex controller.
i
Note:
1. To enter Range Confirmation Test press and hold the side button until all LEDs
blink (about 5 seconds)
A stuck button will cause a repeating red
Test Menu
1.
Disable all repeaters in range
2.
The station should only be linked to one controller
when running the test
.
Reset
Range Confirmation
Reserved for future use
Factory use only
Factory use only
CR2032
Battery Tray
Test Button
(Access From Side)
3
Advertisement
