Advertisement
9. Install a nut insert into each of the drilled holes
7).
G014834
1. Upper mirror bracket
2. Screw
10. Secure the upper and lower mirror mounts to the nut
inserts with 4 screws (1/4 x 1 inch) as shown in
7.
11. Secure the mirror to the mirror-mounting bracket with
the screw and washer
1. Mirror
2. Washer
12. Adjust the mirror(s) to the desired position.
2
1
2
3
Figure 7
3. Nut insert
(Figure
8).
1
2
3
G014835
Figure 8
3. Screw
Installing the Side Mirror Kit
(Figure
(for Machines with a Canopy)
1. Locate the windshield-mounting holes in the front
canopy-support tubes
Note: The left canopy front-support tube is shown
in
Figure
1
g014834
Figure
1. Windshield-mounting hole
2. Vertically center the mirror-mounting bracket to the
windshield-mounting hole, and use the bracket to mark
the location of the holes
3. At the marked location, drill 2 holes (5/16 inch)
through both walls of the tube
g014835
3
(Figure
9).
9.
2
G014837
Figure 9
2. Mirror-mounting bracket
(Figure
(Figure
g014837
9).
9).
Advertisement
