Installing Stainless Steel Handle - Whynter RED WHITE SPARKLING BWR-18SD Instruction Manual

Model BWR-33SD 33 bottle wine refrigerator
① Lock Screws
④ Right Top Hinge

Open the glass door and remove the two lock screws holding the door shaft assembly to the glass
door. Be careful to hold the glass door firmly after removing the screws. (Fig. 1)

Pull down to remove the glass door and place it on a padded surface to prevent scratching it.

Remove the two screws from the door bottom at left side and install them to the door bottom at right
side. (Fig. 3)

Remove the lower door hinge and turn around 90° then install it at the left side. And install the door
shaft assembly accordingly. (Fig. 2)

Remove the door axle from the right upper hinge then install and tighten it in the left upper hinge.
(Fig. 4)

Set the glass door to the designated position and install the two lock screws to connect the door shaft
assembly with the glass door and tighten them before the door is leveled. (Fig. 5)

Remove the handle from the left side of the door and install it on the right side.
 INSTALLING STAINLESS STEEL HANDLE
This appliance includes a stainless steel handle that is not required to operate this appliance. To install
the handle please follow the below instructions:
1. Remove the door gasket on the side you
wish to install the handle - you can see two
designated holes for handle installation. The
gasket is easily displaced by hand, no tools
are necessary.
2. Install the handle tightly as shown with two
screws, lock washers and flat washers
provided. (DO NOT over tighten as this will
cause damage to the handle and stainless
steel door frame).
3. Replace the door gasket to its original
position.
② Right Lower Hinge
⑤ Left Lower Hinge
③ Door Shaft Assembly
⑥ Left Top Hinge
Gasket
Flat Washer
Lock Washer
Screw
9
Handle
Door Frame