Sony KDL-22PX300 Manual page 28

SEC.3 T
SEC.3 T
3-1. Steps After Replacing the T-con Board
Note: Before operation, disconnect all cables connected to the set.
1. Replace the T-con board.
2. Specify the following from the Service menu:
a. Specify PRETEND_ID of DL in PEM.
3. By using the USB memory, upgrade Software.
4. Re-specify the following from the Service menu:
a. Specify DATA_TRANS_SET of TCON_CHANGED in PEM.
b. Specify DATA_TRANS_EXE of TCON_CHANGED in PEM.
c. Check whether or not DATA_TRANSFER succeeded.
5. After turning off and on the power, confirm the Software Version from the Service menu.
6. Conclude the operation.
AZ1 VERSIONUP PROCEDURE(EU)
- CON BOARD
- CON BOARD
28