White Rodgers 1F97-51 Operation Manual page 23

7. Press RUN once. The display will show the
PRGM
correct time and room temperature alter-
nately.
Select Heating and Cooling Temperatures
During programming, if you don't press any
buttons for 5 minutes, the thermostat will enter
the HOLD mode and will maintain a constant
temperature. The display will revert to the alter-
nating time/temperature display. To resume pro-
gramming after this happens, press
you are at the point where you stopped program-
ming. Then you may continue to enter your
programs normally. If you want to stop program-
ming at any time, simply press
program operation.
1. Press
2. Press
3. Press either
VIEW
until
PRGM
4. Press
RUN to resume
PRGM
SYSTEM
until HEAT is displayed.
SWITCH
VIEW once. The display will continue to
TEMP
show HEAT. Below HEAT is the letter A,
representing the first programmed heating
temperature (HEAT A). At the right of the
display is the currently programmed HEAT
A setting.
or
temperature to your selected HEAT A set-
ting. (If you only want to program a tempera-
ture for HEAT A, skip to step 7.)
VIEW
once. The letter A will change to
TEMP
the letter B, representing HEAT B.
to change the
23