White Rodgers 1F92W-51 Installation & Operation Manual page 31

HOLD
gram. Press
TEMP
Then choose the desired hold temperature by
pressing or
hold the room temperature at the selected set-
ting until you press
eration again. This feature is ideal for energy
conservation when the building is unoccupied
for an extended period of time.
• F/ C CONVERTIBILITY — Press
TIME
at the same time until the temperature
BACK
display is in C (Celsius). To display F, repeat
the process.
• ADJUSTABLE HEATING AND COOLING
CYCLE TIMES (ANTICIPATION) — If the heat-
ing/cooling system is turning on and off too
often (short cycles) or not often enough (long
. HOLD will be displayed.
. The thermostat will
HOLD
to start program op-
TEMP
TIME
FWD
cycles), you may want to adjust the anticipation
setting.
An anticipation setting of less than 10 may
cause decreased compressor life.
To adjust HEAT anticipation, press
SET
at the same time. The display will show
DAY
HEAT 18. You may select any anticipation
and
setting from 4 to 40 (note that for add-on heat
pump systems, a minimum anticipation of
10 is recommended). When you adjust antici-
pation, increase or decrease the displayed num-
ber by only one or two digits, then let the system
run for a while to see if the adjustment is
sufficient. If the heat cycles are too short, press
TIME
to increase the cycle time. If the heat
FWD
CAUTION
!
SET
and
CLOCK
31