Explo DMX Manual page 7

3.2 Explanation of switch 9
Mastermoduel-use: As long as the switch position is at "ON" the last used opening time is
locked, and it is possible to assign a set Jet-number to the CO²-jet, by changing the switches
1-8.
IMPORTANT: Setting the Jet-number uses Binary code (
1-8" - "Setting the DMX-adress") and can only be done at CO²-Jets that are switched on.
Should there be Jets without a numbering behind the set CO²Jet, these will line up
accordingly behind said numbered Jet.
Eg.: ( Jets are connected to a Mastermodule. The third Jet is set to adress 5. The fourth Jet
would then activate at adress 6, the fifth at adress 7, etc...
In the graphic below, you can see how 10 CO²-Jets in series connected to a Mastermodule
behave (CO1 to CO10, where CO1 is the Jet directly at the Mastermodule, and CO10 is the
last in line), if one or more CO²-Jets have an assigned Jet number. Set numbers are shown
in the blue fields.
CO 1 CO 2 CO 3 CO 4 CO 5 CO 6 CO 7 CO 8 CO 9 CO 10
1 2
1 2
6 7
1 2
1 2
1 1
IMPORTANT: CO²-Jets, whose number is above 16 do not ignite. Therefore, in the
graphic below, the Jets CO7 to CO10 would not activate!
CO 1 CO 2 CO 3 CO 4 CO 5 CO 6 CO 7 CO 8 CO 9 CO 10
1 2
DMX-use: Switch 9 has no effect during DMX-use.
3 4 5
3 7 8
8 9 10
5 6 7
9 10 11
1 1 1
3 4 15
see "Explanation of switches
6 7 8
9 10 11
11 12 13
8 12 13
12 1 2
1 1 1
16 17 18
9 10
12 13
14 15
14 15
3 4
1 1
19 20
7