Eaton Cutler-Hammer PanelMate ePro PS 7685T-12 Series Replacement Procedures

Replacing the PanelMate® ePro PS, PanelMate ePro PS EE, and
PanelMate ePro PS OD 7685x-12 Series Backlight Assembly
Introduction
The Backlight Replacement Kit provides a replacement backlight for the PanelMate ePro PS 7685T-12
Series, the PanelMate ePro PS EE (Enterprise Edition) 7685T-12E Series, and the PanelMate ePro PS
OD (Outdoor) 7685T-12OD Series. Although the figures provided are for the ePro OD models, the
disassembly for the ePro PS and ePro EE models are the same.
Contents
•
Tywrap
•
Backlight
•
Disposable Anti-static Wrist Strap
Caution: Electrostatic Discharge (ESD) can damage static-sensitive electronic components. You
should perform these procedures only at an ESD workstation. If an ESD workstation is not
available, you can provide some protection by wearing an anti-static wrist strap and
attaching it to a metal part of the system chassis.
Warning: This procedure requires electrical and mechanical skill and should be attempted
only by qualified technicians.
Required Tools
•
Phillips screwdriver size P0 and P1. Magnetic would be helpful.
•
Nut Driver or socket size ¼"
•
Jewelers small phillips screwdriver. Magnetic would be helpful.
•
Small electronic cutters
February 2006 Page 1 of 9 01-50605-00