Maintenance, Storage And Transportation; After-Sales Service And Application Service - Bosch UniversalChainPole 18 Original Instructions Manual

OBJ_BUCH-3155-002.book Page 23 Wednesday, February 28, 2018 10:04 AM
Problem Possible Cause
Pole Pruner rips, Chain tension too loose
vibrates, does not saw
Blunt saw chain
properly
Saw chain worn out
Saw chain teeth are facing in the wrong
direction
Too much force applied
Cuts per battery charge Battery Thermal Protection operated
too low
Pole pruner cuts out Saw chain over tensioned "too tight"
when sawing
Over pressure applied to saw during cutting
New saw chain
Hard wood
Wood is wet
Saw chain teeth facing wrong way/direction
Over heating of tool
External or internal wiring defect
On/Off switch 16 defective
Flashing red battery Battery not (properly) inserted
charge indicator
Battery contacts contaminated
Battery charge indicators Mains plug of battery charger not plugged in
do not light up (properly)
Battery will not charge
Socket outlet, mains cable or battery charger
defective
Battery and charger defective
Battery pack defective
Charger defective
Maintenance, Storage and
Transportation (see figure P)
 Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as during
transport and storage, remove the battery from the
power tool. There is danger of injury when unintentionally
actuating the On/Off switch with the locking button.
Clean the tool with the cloth before storage.
Remove the oil from the reservoir before storage.
When transporting or storing always fit the guide bar cover.
Note: Please do not hang the tool for storage onto the
branch.
Store and transport telescopic pole pruner with battery
removed and protection blade cover placed.
Bosch Power Tools
Corrective Action
Tension saw chain
Replace saw chain
Replace saw chain
Reassemble with saw chain in correct direction
Reduce force
Battery to cool and restart
Retension saw chain
Reduce force applied to saw during cutting
Reduce force applied to saw during cutting
Reduce force applied to saw during cutting
Allow tool to cool down and restart
Reassemble with chain teeth in correct
direction
Allow tool to cool down and restart
Contact your Bosch Service Center
Contact your Bosch Service Center
Properly insert battery into battery charger
Clean the battery contacts (e.g. by inserting
and removing the battery several times) or
replace the battery
Insert mains plug (fully) into the socket outlet
Check the mains voltage; have the battery
charger checked by an authorised after-sales
service agent for Bosch power tools
Replace battery and charger
Replace the battery
Replace charger
After-sales Service and Application
Service
www.bosch-garden.com
In all correspondence and spare parts order, please always
include the 10-digit article number given on the type p,late of
the machine.
English | 23
F 016 L81 582 | (28.2.18)