OHAUS STARTER 2100 Service Manual page 7

CHAPTER 1 GETTING STARTED
Button
1
Notes: Short Press: Press less than 1 seconds.
2
Long Press: Press and hold for more than 2 seconds.
3
Press and hold the Off button until OFF is displayed, then release the button.
TABLE 1-2. Control functions Starter 2100
Press & release
- Start measurement or lock
current reading
- Confirm temp setting
- Start calibration
- Meter turn on
- Exit, return to measurement
screen
- Entered temperature setup
mode
- Increase temp. value when
in temp. setup mode
- Switch between pH and mV
measuring modes
- Decrease temp. value when
in temp. setup mode
- Start self-diagnosis
Press & hold
for 3 seconds
- Review the latest calibration
data (slope, offset)
- Meter turn off