Advertisement
INSTALLATION
How to Install the Faucet
Install the deck-mount connection(1) onto the connector(3) and adjust the
position as shown. Put the fixing screw(2) into the hole of the connection
and tighten with the wrench(4).
Put the washer(5) into the groove of the deck-mount connection, and
then install the connections into the hole of the bath tub. Thread the
washer(6)(7), nut(8) onto the shank of the connection from the underside
of the bath tub. Tighten the nut(8).
How to Install the Handshower
Remove the guard on the outlet connector firstly.
Put the washer(9-1) into end A of the hose(10), and then connect to the
faucet outlet(11). Put the washer(9-2) into end B of the hose, and install
the restrictor(12) into the handshower(13) inlet if needed, then connect
end B of the hose to the handshower inlet.
How to Operate the Handshower
Press the buttons of the handshower to change the water flow.
How to Maintain the Handshower
Any debris or mineral build-up may cause the flow stream to become
distorted or reduce the flow rate. To remove the debris or mineral build-up,
run water through the handshower, firmly press or rub your finger back
and forth across the rubber nozzles.
1338602-2A-A
3
1
2
4
5
6
7
8
13
12
9-2
B
11
10
A
9-1
Katalyst Air
Intense Massage
2
Remove and clean the screen washer.
How to Install the Bracket
Determine a suitable location on the finished wall to install the bracket.
Mark bracket base mounting hole locations on the wall according to the
dimension. Drill two holes on the finished wall, the holes should match
the anchors(17). Install the anchors. Tighten screws(16) to secure
bracket base(14) to the finished wall. Put the bracket(15) onto the bracket
base and lock by stopper. Hang the handshower on the shower bracket.
INSTALLATION CHECKOUT
Ensure that all coupling nuts are tightened. Ensure that the handle is in the off position. Turn on the drain and main
water supply, and check for leaks. Repair as needed.
Remove the handshower. Remove the aerator by coin. Run hot and cold water through the faucet for about one
minute to remove any debris. Check for leaks. Remove any debris from the aerator assembly. Shut the faucet off,
and reinstall the aerator assembly and handshower.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
1338602-2A-A
14
15
16
17
3
Advertisement
