Re-install (4) 10mm screws saved from Step 2. See Figure 14.
Wire your lights according to the instructions included with the light. Take care to avoid
any heat sources and sharp or abrasive surfaces.
Figure 14:
Your installation is now complete.
Welcome to the Rigid Nation!
WARRANTY INFORMATION
For warranty information, visit www.rigidindustries.com/about/warranty
Follow us on facebook at
Facebook.com/RigidIndustries
779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337 • www.rigidindustries.com
PKG-IS-121-B
E-Series, Rigid Industries and Rigid are Registered and/or common law marks owned by JST Performance, LLC, a Delaware limited liability company d/b/a Rigid Industries.Industries.