Table of Contents
Advertisement
Quick Links
IMPORTANT: After testing it may be
necessary to remove condensate collected
in the water/particle filter that is included
with the probe.
WARNINGS:
To
prevent
ignition
of
flammable
combustible atmospheres, disconnect power
before servicing.
Always change batteries in an environment
free of combustible gases.
Do not handle the steel portion of any hot
air probe during or too soon after sampling.
It will become hot and retain heat and burns
may occur!
851 Transport Drive
Valparaiso, IN 46383-8432
or
Innovative Detection Solutions
MADE IN USA
Distributed by:
Phone: 219 465 2700
Web:
www.gasleaksensors.com
Quick-Start Instructions
This is not a substitute for the
instruction manual. It is for
reference only.
Read and understand the
instruction manual before use.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SENSIT Technologies HCN
Summary of Contents for SENSIT Technologies HCN
- Page 1 IMPORTANT: After testing it may be Quick-Start Instructions necessary to remove condensate collected in the water/particle filter that is included with the probe. 851 Transport Drive Phone: 219 465 2700 Valparaiso, IN 46383-8432 Web: www.gasleaksensors.com WARNINGS: prevent ignition flammable Innovative Detection Solutions combustible atmospheres, disconnect power before servicing.
- Page 2 14. When your investigation is complete push button “A” and hold for 5 seconds until 6. Look at the display – HCN (and optionally the instrument displays “POWER OFF” then CO) readings are displayed. release to shut off.
Need help?
Do you have a question about the HCN and is the answer not in the manual?
Questions and answers