Alarm Outputs; Serial Communications; Ambient Operating Temperature Range; Power Requirements - Eaton Crouse Hinds Series Instruction Manual

2.10 Analogue output - isolated

2.11 Alarm outputs

2.12 Serial Communications

2.13 Ambient operating temperature range

2.14 Power requirements

2.15 Dimensions

2.16 Weight

INM MTL 130-0183 Rev 6
Output (programmable): †
Isolation:
Maximum load:
Minimum load:
Resolution:
Accuracy:
Linearity:
Minimum under range:
Maximum over range:
Upper error band:
† This is user programmable for full-scale values of between 1ppm and 100% oxygen and zero-
scale values of between 0ppm and 90%.
* Isolation must only be considered as forming basic or function insulation as defined in BS EN
61010-1:2010
2 alarms each user programmable for:
Mode - HIGH, LOW or OFF;
Level - full range of instrument.
Hysteresis - 0% to 10% of set point.
Volt free C/O contacts rated at 48V ac or dc, 0.5A, normally energised.
RS232 interface, 9600 baud, ASCII protocol (see Section 9)
0°C to 45°C (0 - 90% R.H. non-condensing)
24V DC +/- 10%, 24W
A standalone power unit may be specified at the time of order. ( Input: 100 to 240V AC, 50/60
Hz / Output 24V DC )
Instrument
See Section 4 - Figure 1
Sensor/heater
Maximum overall: 68mm (H) x 150mm (L) x 55mm (W)
Lead lengths: 300mm nominal
Enclosure
See Section 4 - Figure 3
Z1030 instrument:
Wall mounted enclosure:
Mains power adapter:
4 to 20mA
1kV *
500 ohms
N.A.
0.01 mA
+/- 0.2% of programmed range
+/- 0.5%
3.8 mA
20.5 mA
21.0 to 24.0 mA
400g
1250g
200g
0 to 5 volts
1kV *
N.A.
10 kohms
2.5 mV
+/- 0.2% of programmed range
+/- 0.5%
N.A.
N.A.
N.A.
3