Using For The First Time - BOMANN TSG 7402 Instruction Manual

WARNING: WARNING:
WARNING: WARNING:
• It is not allowed to modify the plug provided with
the appliance! If the plug does not fit properly to
the outlet, let install a proper outlet by an author-
ized specialist.
• The accessibility of the power plug must always
be ensured to disconnect the device from the
power supply in case of an emergency.
• Make sure that the voltage supply matches the
specifications on the rating label (door frame) be-
fore connecting.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.

Using for the first Time

Using for the first Time Using for the first Time Using for the first Time
CAUTION: : : : CAUTION
CAUTION CAUTION
• Use only salt and detergent for dishwashers. Oth-
er products may damage the unit.
• Always consider the dosage and storage recom-
mendations on the sales packaging.
WARNING: WARNING:
WARNING: WARNING:
Keep salt and detergent out of reach for children.
Filling salt into the salt con Filling salt into the salt container (water softener) Filling salt into the salt con Filling salt into the salt con
Water softener Water softener
Water Water softener softener
The water hardness varies regionally. If hard water is
used in the dishwasher, deposits form on the dishes
and kitchen utensils. The appliance is equipped with
a water softener, that removes lime and minerals
from the water by using water softening in the salt
container. Your local water authority can advise you
on the hardness of the water in your area.
Adjusting the salt consumption Adjusting the salt consumption Adjusting the salt consumption Adjusting the salt consumption
The salt consumption can be adjusted according to
your water hardness therefore optimally regulated.
tainer (water softener) tainer (water softener) tainer (water softener)
• Turn on the appliance.
• Press the Program button for more than 5 sec-
onds, the setting mode is now activated for ap-
prox. 60 seconds.
• By repeatedly pressing the Program button, the
water hardness can be selected: H1->H2->H3
->H4->H5->H6. The display indicates the selec-
tion (see below table).
• The setting is automatically saved after a few
seconds; alternatively end the setup with the
Power button.
Water hardness Water hardness
Water hardness Water hardness
°dH °dH Mmol/l Mmol/l
°dH °dH Mmol/l Mmol/l
0-5 0-0.94
6-11 1.0-2.0
12-17 2.1-3.0
18-22 3.1-4.0
23-34 4.1-6.0
35-55 6.1-9.8
NOTE: : : : NOTE
NOTE NOTE
°dH: German degree of hardness
Factory setting: H3
Fill in the salt Fill in the salt Fill in the salt Fill in the salt
CAUTION: CAUTION:
CAUTION: CAUTION:
• Only refill the salt container when the salt warning
lamp is lighting.
• During filling the salt container, salt and water can
escape. Start a program immediately after you
have filled the container to prevent corrosion.
• Remove the dishwasher basket and unscrew the
lid of the salt container.
• Add about 130 g of salt by using the supplied
funnel tube.
• Full fill the salt container with water (just before
the first use).
70
Setting → → → → Setting Salt cons. Sa lt cons. / / / /
Setting Setting Sa Sa lt cons. lt cons.
Display Display Display Display cycle cycle cycle cycle
H1 0 g
H2 4 g
H3 8 g
H4 13 g
H5 20 g
H6. 40 g