General Description
The Input-Output device FD7203 ( g.1) is designated to produce and send an electrical signal
to various devices in case of occured events and recording external impacts, typical for a re
condition events.The device is compatible with addressable re control panels IFS7002,
supplementing the possibilities of the addressable systems of series IFS7000.
The device consists of a printed board with elements,
mounted on a plastic base and closed by a cover .The
base has an implemented terminal bus (pos.7 and pos.6,
g.1) through which cabels connect the addressable loop,
the power supply and etc.
Communication between Control Panel IFS7002 and the
input-output device is realized by means of the
addressable loop through a specialized protocol for data
exchanging UniTALK .
Two LED indicators are built-inon the device PCB (pos.1
g.1), illuminated in yellow and red (pos2. g.1) light,
providing device status information.
chnical Data
ddressable loop:
- supply voltage
- current consumption in duty mode
- current consuption in alarm state
Input:
- "Fault condition" - interruption
- "Fault condition" - short circuit
- "Duty mode" range
- "Activated input" range ( g.3b)
- "Activated input" - input does not check for short
circuit ( g.3a)
Output: Depending on the con guration and the power supply
(Relay or monitored)
• Relay
- type
- electrical speci cations
or
• Monitored
- type
- electrical speci cation
- peak activation current
Degree of protection:
Operating temperature range
Relative humidity resiatance (no condensation)
Dimensions
Weight
Manufacturer: UniPOS Ltd., 47 San Stefano Street, Pleven 5800, Bulgaria, http://www.unipos-bg.com
Fig.1 - Picture of input/output module
(15÷30)Vdc
< 350µA
(2±1)mA
1 pc.
R
>25k
line
R
≤2,2k
line
5,7k ≤R
<15k
line
2,2k <R
<5,7k
line
0k <R
<5,7k
line
1 pc.
potential free,
switching functions
30V DC /1A, 125V AC/0,5A
potential
(12÷30)Vdc
400mA
30
IP
from minus 5° to 40°
(95±3) % at 40°C
(90x66x22) mm
0.075 kg
09/09.19