Table of Contents
Advertisement
Performance Data Sheet @
Q
This Reverse Osmosis System has been tested and listed by NSF International
under Standard 58 for the water treatment claims listed below under
"Contaminant
Reduction Performance".
Whirlpool Reverse Osmosis Water Filtration System IV
Model No. WSR413YW
Test Parameters
TDS = 200500
mg/L2 pH = 7.5
Turbidity = 1 NTU
Temperature
= 77°F
Pressure = 50 psig
'USEPA
Maximum
Contaminanl
Level or Action Level (mg/L).
3arrium.
Cadmium
and Chromium
were tested at 750 mglL TDS.
3The reduction
of Radium
was verified by using Barium
as a surrogate
under NSF prolocol.
'These
conlaminanls
are not necessarily
in your water supply. Periormance
may vary based on local water conditions
In addilion
to the contamlnanls
listed above. these systems
also have Ihe ability to effectively
reduce non health-related
chemicals
llke Chlorides,
Phosphate,
Sodium and Sulfates
I
APPLICATION
GUIDELINES/SPECIFICATIONS
AND FEATURES
Membrane
TvDe
1
TFCM
I
Water SUDDIV Parameters
Water Supply-Community
or Pnvate Well
Chlorinated
Onlv
I
Chemical
Limit
Hardness
~350 ma/L
I
Water Pressure
1 40-l 00 psi (3-7 Kg/cm2)
1
Iron
1 co.1 mg/L
I
Water Temperature
1 40"-100°F
(4.4 - 36°C)
1
Manganese
co.05 mg/L
DH Ranoe
4-11
I
Hvdroaen Sulfide
I
0
I
Maximum TDS Level
I
2000 ppm
I
Turbidity
I
cl NTU
I
CAUTION:
Da Not usa where water is microbiologically
unsaie or with water of unknown
quality
Waler supplies
that exceed limits lor Hardness,
Iron, Manganese.
Hydrogen
Sulfide require pretreatment.
I
Important
Quality Assurance
Requirements
This Reverse Osmosis Drinking Water system contains treatment components
that are
critical for effective reduction of Total Dissolved Solids as well as inorganic contaminants.
A water quality monitor (indicator light disk) is build into the system to provide the user with a
means to test the water at any time. Refer to "Use and Care Information"
for operation of the
water quality monitor (indicator light disk).
Routine
Maintenance
Sediment Prefilter, Carbon Prefilter and Carbon Postfilter: Change once per year'
Membrane: Change as required based on the built-in water quality monitor.
*Refer to "Use and Care Inlormation"
for additional
conditions.
Purification
Assembly
Components
General Performance
Sediment Prefilter:
5 micron Nominal Depth
Testing Laboratory'
Cartridge
System Production:
10.3 gal/day (39 liters/day)
Carbon Prefilter:
Activated Carbon
Minimum TDS Reduction:
96%
Membrane Type:
Thin Film Composite
(TFCM)
'Raed
at 50 psi, 77°F. 750 mg/L N&I,
product
to storage tank.
Carbon Postfilter:
Activated Carbon
Standard
Tank Capacity:
2.6 Gallons maximum.
Factory
Specifications**
Factory sanitized and ready to install.
Membrane
Production:
14-20 gal/day High-
Reject Water: This drinking water appliance has a
Flow Membrane
self cleaning feature that requires approximately
Membrane
TDS Reduction:
96% Minimum
3 gallons of rinse water for every gallon of high
"Rated
at 60 psi, 77°F. 350+ mglL TDS, product
lo atmosphere.
quality water used.
Note: Actual produtiion
rate and TDS reduction
will depend
upon temperature.
water pressure.
TDS level, membrane
variation
and usage pattern.
All Drinking Water Appliances
are factory tested, sanitized and prepared for installation.
WARRANTY
Length of Warranty:
One Year Full Warranty
(from date of purchase)
Whirlpool
will pay for:
Replacement
parts and repair labor to correct defects
in materials or workmanship
for the entire product
except for the filter cartridge(s).
Servicing must be
provided by an authorized Whirlpool servicing outlet.
Five Year Limited Warranty
(second through fifth year
from date of purchase)
Whirlpool
will not pay for:
A. Service calls to:
Replacement
parts to correct defects in materials or
workmanship
for the entire product except for the
filter cartridge(s).
1.) Correct the installation
of the product.
System must be installed and operated in accor-
dance with Whirlpool procedures
and guidelines.
2.) Instruct you how to use the product.
3.) Correct house plumbing.
El. Repairs when product is used in other than normal, single-family
household
use.
C. Repairs when product is damaged from neglect, misuse, abuse, freezing or hot water, fouling
with sediment or scale, bacterial attack, alterations,
improper installation,
or installation
not in
accordance
with local plumbing codes.
D. Any labor costs during the limited warranty.
E. Replacement
parts or repair labor costs for units operated outside the U.S.
F. Pickup and delivery.
This product is designed to be repaired in the home.
G. Repairs to parts or systems caused by unauthorized
modifications
made lo the product.
The performance
and functioning
of your water filtration system is directly related to the quality of
the water being treated and the particular application
in which it is used. Please consult "Water
Requirements"
and "Use & Care".
Whirlpool
shall not be liable for Incidental
or consequential
damages.
Some states do not allow
the exclusion or limitation of incidental or consequential
damages, so this limitation or exclusion may
not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
17
Advertisement
Table of Contents
