Advertisement
Energy saving tip
If you plan to be away
from home more than two days,
you
may want to turn the temperature
control to "OFF" to
eliminate
energy
consumption
during
your absence.
You will
not
save any energy
by turning the dispenser
off at night and back on the next morning.
Caring for your hot water dispenser
Winterizing
Be sure to safeguard
your dispenser
when it is exposed
to freezing
temperatures.
Drain the storage
tank to prevent
the water inside from freezing.
Freezing will ultimately
damage
the storage
tank:
To Drain:
1.
Unplug the power cord.
2. Turn Temperature
Control Knob to "OFF."
3. Run hot water dispenser
until water is cold.
4. Place at least a 3-quart capacity
container
under the drain plug on the storage
tank.
5. Unscrew the drain plug with a %a" wrench
and allow all water to drain.
6. Replace
and tighten the drain plug.
Do not
overtighten.
TEMPERATURE
CONTROL KNOB -
DRAIN PLUG \
When
ready
to use the dispenser
again,
see "Using your hot water dispenser."
CAUTION:
DO NOT TURN UNIT ON IF TANK IS EMPTY. Damage
to the unit will result
and
is not covered
by the warranty
Cleaning the Spout Screen
If you have very hard water, it may be necessary
to clean the Spout Screen occasionally
To Remove:
1.
Remove
the two spout screws.
2. Remove
spout base plate.
3. Pull the screen assembly
out of the hot water
tube.
To Clean:
1.
Use a small brush and vinegarto
remove
deposit
2. If deposit
has hardened,
soak in vinegar
for
an hour or two. Then brush clean.
3. Replace
screen assembly
in tube and
screw plate back onto spout.
Advertisement
