Graphic Installation - Testrite Visual Charisma SEG XSS Custom Adjustable Series Manual

Charisma™ SEG Stand - XSS Custom Adjustable Series
1. To install the graphic, take the corner with the pull tag on it and press about 6"-10" of silicone into the frame channel corner A. Repeat for the
opposite corner B. Repeat for the next corner C. Lastly, repeat for the final corner D.
2. After all corners are pressed in, press the silicone into the frame channel at the mid-points on all four sides.
3. Press silicone into frame evenly between the corner and midpoints.
This prevents the graphic from bunching up or stretching too much and will ensure a smooth and tight fit.
4. To remove the graphic from the frame, simply pull up on the pull tag.
5. Repeat steps 2-4 on the second side, if applicable.
1.
(b)
(c)
(a)
pull tag
3.
2.
(d)
4.
pull tag
Version: 1 Page 2 of 2