Testrite Visual Charisma SEG XSS Custom Adjustable Series Instruction Sheet

Charisma™ SEG Stand - XSS Custom Adjustable Series
SIDE
The frame pieces with a sticker and circled number stickers
BOTTOM
will not have any stickers, unless the horizontal sides are split in two sections. Each two-section horizontal side will have matching rectangular number
1 1 2 2
stickers, and , and , etc., at the joining point.
1. For each frame corner, align the holes of bracket with the holes on the frame and lightly tighten using the small Allen screws provided. Repeat for
all four sides of the frame. Once completed, go back and fully tighten all the screws.
2. If applicable, place frame joiner in between the horizontal frame halves. Align frame holes with joiner holes and use the screws provided to secure.
3. Place center support bar bracket into frame channel and use an Allen key to expand the bracket inside the channel to secure it in place.
4. Align uprights with base holes and attach using the large flat head Allen screws provided. When inserting screws, tighten BOTH by hand first. Then,
fully tighten using an Allen key.
5. Install the graphic per the instructions on page 2.
6. Mounting the frame: Orient the frame with the
indicated by the circled number stickers
the four holes on the frame, matching the desired height position.
1.
3.
6.
, ,
1 2
SIDE
stickers pointing to the ground. The frame has mounting holes at three height positions
BOTTOM
,
and . Attach the four puck screws provided, through the uprights and fasten the puck screws to
1 2 3
2. (If applicable)
joiner
4.
Position 2
Position 1
1 1 2
1
1
2
3 are the vertical sides of the frame. The horizontal sides of the frame
5.
Graphic Install - See next page
Position 3
2
3
2
3
Step 2
Step 1
Step 6
1
2
3
Step 6
1
2
3
SIDE
BOTTOM
Step 1
Step 4
Step 2
3
3
Step 3
Step 3
Version: 2 Page 1 of 2