Washer Operating; Starting Your Washer - Whirlpool Thin Twin LT5004XS Use & Care Manual

Washer Operating Instructions
The drawings in this book may vary slightly from your washer model. They are
designed to show the different features of all the models covered by this book.
NOTE: Your model may not include all the features shown.
Starting your washer
Be sure to measure and add detergent, then place a sorted load in the washer before
starting it.
1. Select a load size
l
Turn the knob to point at a setting
that describes the size of load you
want to wash.
l
Set the knob on or between EX
SMALL (a few items) and LARGE
(a full load).
NOTE: Use the LARGE water level for
best permanent press results.
2. Select water temperature
l
Match the water temperature to the
type of fabric and soils being washed.
l
The top temperature is the wash
selection and the bottom temperature
is the rinse selection.
NOTE: Use warm wash water with
the PERMANENT PRESS or KNITS/
GENTLE Cycles.
For heavily soiled permanent press
or knit clothes, pre-wash or presoak
before washing in warm water.
ALWAYS use cold rinse water for
permanent press fabrics.
3. Select cycle and wash time
Start the washer
l
Push in the Cycle Control Knob an
turn it to the right.
l
Stop on the number in the waste Cycle
you want. The numbers are niinutes Of
wash time.
l
Start the washer by pulling out the
Cycle Control Knob. The washer
Will
fill to the selected water level with the
selected wash w dter temperature.
After filling, the washer will agitate for
the selected nrumber of minutes.
l
To stop the washer at any time, push
in the Cycle Control Knob. To restart
the washer, PI III out the Cycle
Control Knob.