Drill/Hammer Drill Selection Dial - Bosch 11250VSR Operating/Safety Instructions Manual

BM 1619929567 10-03 3/2/04

DRILL/HAMMER DRILL SELECTION DIAL

The selector dial allows the tool to be set for
various drilling/hammer drilling applications.
Depress release button and turn selector dial
right or left depending on the below
applications.
Do not
CAUTION
!
selection dial until the tool
come to a complete stop. Shifting during
rotation of the chuck can cause damage to
the tool.
Do not use demolition or chipping bits such
as bull points, chisels, spades, gouges, etc.
Disconnect the plug from the
WARNING
!
power source before making
any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
The 11250VSR Rotary Hammer utilizes
"SDS" drill bits. The "SDS" system efficiently
transfers drilling torque and maximizes the
energy delivered per hammer blow.
Clean the insert shank end of the accessory
to remove any debris, then lightly grease
with a light oil or lubricant.
Insert accessory into the tool holder through
the dust shield, while twisting and pushing
When removing the bit from
WARNING
!
the tool avoid contact with
skin and use proper protective gloves when
grasping the bit or accessory. Accessories
may be hot after prolonged use.
To remove an accessory, pull the locking
sleeve backwards (towards the rear of tool),
while pulling the accessory outward. All
accessories should be wiped clean after
removing (Fig. 6).
9:40 AM Page 8
operate the
INSTALLING ACCESSORIES
inward until it locks automatically into place.
Pull outward on the accessory to be certain
it is locked into the tool holder (Fig. 5).
FIG. 5
DUST SHIELD
REMOVING ACCESSORIES
FIG. 6
-8-
Drill only action: For drilling in
woods, metals, plastics or
other non concrete materials.
Drill with hammer action: For
drilling in concrete, asphalt,
tile or other similar hard
materials.
LOCKING
SLEEVE