Table of Contents
Advertisement
Available languages
Available languages
3
Mounting
In parallel to this mounting instruction, please also
refer to the installation instructions as well as
hazard and safety instructions in the user manual
of the respective wireless actuator.
To install the button rocker and the clip-on frame, please
proceed as follows:
•
Place the clip-on frame (A) onto the installed
Homematic IP actuator (see fig. 2). Alternatively,
you can continue using the existing frame with an
inner dimension of 55 mm (see "4 Mounting into
frames of other manufacturers" on page <?>).
Place the push-button rocker (C) with the already
•
inserted adapter (B) into the clip-on frame, so that
both latching lugs fit into the existing elongated
holes (see figure 3).
Mounting
15
Advertisement
Chapters
Table of Contents
