Data Thermometer Quick Start Guide
1. Install batteries.
Battery
Compartment
Retaining Screws
Gasket
2. Press
to turn the instrument on.
3. Connect a compatible temperature probe to the Channel 1 and/or
Channel 2 input connector located at the top of the instrument.
4. Set the desired thermocouple type and temperature units as follows:
a. Enter Setup Menu by pressing
1.5 seconds, and then release it;
b. The Active Thermocouple Type will flash on the display. Use
select the thermocouple type of the connected temperature probe
(B, E, J, K, N, R, S, or T);
c. Press (do not hold)
d. The Active Temperature Unit will flash on the display. Use
the desired temperature unit (°C, °F, or K);
e. Press (do not hold)
5. To begin collecting temperature data that will be stored in the thermometer's
onboard memory, press
931-901 Rev. C English
THERMOMETER 931A/B, 932A/B
Battery Installation
Remove the two (2) battery compartment
retaining screws and the battery compartment
cover on the back of the instrument. Install
three (3) AA 1.5 V batteries (supplied with new
instrument). Be sure the battery compartment
gasket is properly installed and replace the
battery cover.
– hold key down for approximately
to save selection and move to next parameter;
to save selection and exit Setup Menu.
.
to
to select
1