Advertisement
Step 1
Check if the DIN-Rail mounting kit is installed firmly.
Step 2
Insert the bottom of DIN-Rail mounting kit (one side
with spring support) into DIN-Rail, and then insert
the top into DIN-Rail.
Tips:
Insert a little to the bottom, lift upward and then insert
to the top.
Step 3
Check and confirm the product is firmly installed on
DIN-Rail, then mounting ends.
【Disassembling DIN-Rail】
Step 1
Device power off.
Step 2
After lift the device upward slightly, first shift out the
top of DIN-Rail mounting kit, then shift out the
bottom of DIN-Rail, disassembling ends.
Note before powering on:
Power ON operation: first connect power line to the
connection terminal of device power supply, then power
on.
Power OFF operation: first unpin the power plug, then
remove the power line, please note the operation order
above.
【Power Supply Connection】
DC power supply
This device provides 3-pin industrial terminal blocks (1, 2, 3),
among which 1 and 3 are 12~48VDC power supply inputs.
This power supply supports non-polarity, it
could
run
normally
connected.
【DIP Switch Setting】
Provide 4-bits DIP switch for function setting,
where "ON" is enable valid terminal. The
definitions of DIP switch as follows:
No.
Definition
Operation
1
Flow control
Set the switch to ON
2
Specified 100M
Set the switch to ON
3
Remote alarm
Set the switch to ON
4
Jumbo frame mode
Set the switch to ON
【Checking LED Indicator】
The device provides LED indicators to monitor its operating
status, which has simplified the overall troubleshooting
process. The function of each LED is described in the table
below:
LED
Status
Description
ON
/
Device is in an abnormal state
OFF
RUN
Blinking
Device runs normally
Power supply is connected and
ON
running normally
PWR
Power supply is disconnected or
OFF
running abnormally
Local copper port is connected
ON
properly
Local copper port is in an active
LINK(G1)
Blinking
network state
Local
copper
OFF
connected
Local fiber port is connected
ON
properly
Local fiber port is in an active
LINK(G2)
Blinking
network state
OFF
Local fiber port is not connected
when
reversely
ON
LFP(G1)
OFF
ON
LFP(G2)
OFF
【Specification】
Panel
Gigabit SFP
Gigabit copper port
Gigabit fiber port
Indicator
Switch property
Backplane bandwidth
Buffer size
MAC address
Power supply
Input power supply
port
is
not
Terminal blocks
Power consumption
Remote
copper
port
is
not
connected
or
connected
abnormally
Remote copper port is connected
properly
Remote
fiber
port
is
not
connected
or
connected
abnormally
Remote fiber port is connected
properly
1000Base-X, SFP slot
10/100/1000Base-T(X)
self-adaption,
RJ45
port,
self-adaptive full/half duplex
mode or specified operating
mode, supports
MDI/MDI-X
self-adaption
1000Base-X,
optional
SC/ST/FC
Power
supply
indicator,
running
indicator,
port
indicator, LFP indicator
12G
1Mbit
1K
DC power supply product
12～48VDC
Support
non-polarity
and
anti-reverse connection
3-pin 7.62mm pitch terminal
blocks
Advertisement
