Advertisement
Quick Links
PAPER
CALIBRATION
Make sure Ozobot is
1
powered off, then
place it in a black circle
slightly bigger than
Ozobot. If you are
using markers, create
this circle using a black
marker.
3
DRAWING
LINES
Too Close!
COLOR CODE TIPS
X
Ozobot blinks green when
calibrated. If Ozobot blinks red,
start over from step 1. Evo also
spins during calibration.
Too Thin!
Too Thick!
Just Right
2
Press & hold Ozobot's
Power Button for 2-4
sec. until top light
blinks white. Then,
release Power Button.
4
Press the Power Button to turn Bit back on.
Evo powers on automatically after calibrating.
Inconsistent!
Too Sharp!
ozobot.com
Just Right
Just Right
Just Right
2-4 sec.
© Ozobot Inc.
Advertisement
Related Manuals for Ozobot Evo
Summary of Contents for Ozobot Evo
- Page 1 Ozobot blinks green when calibrated. If Ozobot blinks red, start over from step 1. Evo also Press the Power Button to turn Bit back on. spins during calibration. Evo powers on automatically after calibrating.
- Page 2 Too close to Place codes away Too close intersection from intersections GO LEFT Codes too close Codes at least 1” apart Align with straight, black lines At least 1-inch from GO LEFT corners, intersections, and other codes ozobot.com © Ozobot Inc.
- Page 3 These calibration dots can be re-used for play on paper with Evo or Bit. Cut along the dotted lines and fill circles in with black marker. CALIBRATION DOT Note: Do not laminate as your bot cannot TEMPLATES properly calibrate on a laminated surface.
Need help?
Do you have a question about the Evo and is the answer not in the manual?
Questions and answers