Advertisement
Quick Links
Advertisement
Related Manuals for Ozobot ORA
Summary of Contents for Ozobot ORA
- Page 1 Quick Start Guide...
- Page 2 Your ORA Username & Password Locate your unique ORA username and password on page 3 in your manual. Do NOT discard this manual to avoid losing your username and password. If you need assistance, please contact support@ozobot.com and we’d be happy to help.
- Page 3 Materials Unpack your ORA ensuring that all pieces are included in your package. End Tool: End Tool: Gripper Vacuum Gripper Quadrant Ethernet End Tool C–Clamp Data Cable Adapter Cable Emergency Mounting Power Power Vacuum Lock Stop Button Plate Cable Supply Cable...
-
Page 4: Technical Specifications
Side View +/– 0.5mm Payload 600 g Motor Type DC Brushless 165 mm Control Box Built–in Power In 100–120 V ~ 8A 440 mm 440 mm Top View 880 mm ORA Physical Boundary Extents ORA Quick Start Guide — Technical Specifications... - Page 5 Joint 4 Joint 3 –3.5 deg ~ 300 deg Joint 4 +/– 360 deg Joint 5 +/– 124 deg Joint 6 +/– 360 deg Joint 2 Joint 5 Joint 1 Joint 6 ORA Joints ORA Quick Start Guide — Technical Specifications...
- Page 6 How–To Video Before operating the arm, ensure the space around your Scan the QR code to watch a step–by–step ORA setup video. ORA is clear of objects and people. Check that the correct movement speed has been set before running a program.
- Page 7 Mounting Plate and tighten with the M5 Hex Key. securely fasten the Baseplate to the surface. ORA can be securely mounted to the edge or middle of a For attaching to an edge of a surface, please refer below: stable surface.
- Page 8 For attaching to an edge of a surface — with half the quadrant mat: connect the top half of the ORA Quadrant Mat together around the base of your ORA, using the two half mat end pieces. Materials Needed for Edge of Surface...
- Page 9 Fasten ORA to the Center of a Surface Connect the cables and accessories To mount your ORA away from the edge of the mounting Next, connect the Emergency Stop Button, Ethernet Cable, surface, use 5 mm diameter hardware (4) to fasten the and Power Supply Cables to the rear interface as shown.
- Page 10 Step 1 Power on ORA Note: Connect your ORA via Ethernet Cable to your local area network (LAN). It is recommended to connect you Enable power to your ORA by switching ON the Power control computer via Ethernet Cable, as connecting over Supply, and then twisting the Emergency Stop Button to the Wi-Fi may result in delayed responses from the arm.
- Page 11 Go to (ORA Editor) and connect ORA Using either Google Chrome or Microsoft Edge browsers, Locate your ORA name and password at the beginning of navigate to editor.ozobot.com this manual, on page 3. Name and password can also be found on the bottom of your ORA base.
- Page 12 ORA Name: Logic Loops Password: Math Text Connect ORA Status should now read “Standby”. All prepared! For calibration, you will need the End Tool: Gripper and Run Code Calibration tool. See page 24 for connecting an end tool. Movement Standby...
- Page 13 Joint 6. Step 1 Power off ORA Materials Needed Before mounting or unmounting an End Tool, press the Emergency Stop Button to shut off power to ORA. Press the button to shut OFF power to the arm. M6 Hex M6 Screws L–Key...
- Page 14 ORA Editor and more. End Tool Adapter Cable Your ORA setup is now complete. For troubleshooting or additional support, please contact support@ozobot.com or visit ozobot.com/ora to explore FAQs. Connecting End Tool...