Assembly; Assembling The Curved Handle; Operation; Hanging On/Removing The Grass Bag - Grizzly ERM 1743-20 Translation Of The Original Instructions For Use

Assembly

Disconnect the plug before any
work on the equipment. There is a
risk of injury.

Assembling the Curved Handle

For a simple holmm installation,
select cutting height 20 mm (see
„Adjusting the cutting height").
1. Remove the two pre-installed
B
butterfly nuts (2a) from the
lawnmower housing (7). Insert
the lower bar (3) into the slot on
the lawnmower housing (7).
2. Fix the bottom bar (3) using the
two screws and butterfly nuts
(2a).
3. Fix the curved handle (1) using
C
the enclosed screws (16) and
the wing nuts (2b) on the lower
bar (3). There are two possible
positions.
4. Clip the cable hooks (10) into
the bar (3) and the handle (1) to
fasten the cable.
When both wing nuts are loosened,
the curved handle can be folded
down for storing the equipment.
Ensure that the power cable is not
caught.

Operation

Hanging On/Removing the
Grass Bag
D 1. To hang on the grass bag (4), lift
the collision guard (9) and hang
on the grass bag. Fold the col-
lision guard (9) onto the grass
bag (4). It holds the grass bag
in the correct position.
2. To remove the grass bag (4),
lift the collision guard (9) and
detach the grass bag. Fold the
collision guard (9) back onto the
mower housing.
Do not work with the lawnmower
without the collision guard or
lawn box. There is a risk of in-
jury.
E

Level gauge

The level gauge (17) is located on the
side of the grass catcher (4).
Flap (17) open:
grass catcher (4) empty
Flap (17) closed:
grass catcher (4) full
The level indicator (17) works
when the device is in operation.

Emptying the Grass Bag

To empty the grass collection bag, also
use the bottom bag handle (4).
GB IE NI
29