Installing Software - Panasonic UT-MA6 Series Operating Instructions Manual

Installing Software

Installing software will return the computer to the default condition. When you install the soft-
ware, the flash memory data will be erased.
Back up important data to other media or an external hard disk before installation.
CAUTION
l Do not delete the Recovery Partition on the flash memory. The Recovery Partition is not avail-
able to store data.
To check the Recovery Partition, perform the following methods.
A Touch
Ÿ A standard user needs to enter an administrator password.
B Touch [Disk Management].
NOTE
l You can use the following buttons instead of the keyboard.
: ↓ key
: ↑ key
: Enter key
: F2 key (Default setting)
l Connect the AC adaptor and do not remove it until installation is complete.
n Flash memory Recovery
You can reinstall the OS that was pre-installed at the time of purchase.
Preparation
l Remove all peripherals.
1 Turn on the computer, and touch the top left corner of the screen
several times while [Panasonic] boot screen is displayed.
The Setup Utility starts up.
l If the [Panasonic] boot screen is not displayed, turn on the computer while touching the
top left corner of the screen.
l If the password is requested, enter the Supervisor Password.
2 Write down all of the contents of the Setup Utility and touch [Exit] and
double-touch [Load Default Values].
At the confirmation message, touch [Yes].
3 Touch [Exit] and double-touch [Save Values and Reboot].
At the confirmation message, touch [Yes].
Computer will restart.
4 Touch the top left corner of the screen several times while [Panasonic]
boot screen is displayed.
The Setup Utility starts up.
l If the password is requested, enter the Supervisor Password.
5 Select the [Exit] menu, then double-touch [Recovery Partition].
6 Touch [Next].
7 Touch [Reinstall Windows.] and touch [Next].
The License Agreement screen appears.
16
(Start) and long touch [Computer], then touch [Manage].