Installing Software - Panasonic UT-MA6 series Operating Instructions Manual

Installing Software

Installing software will return the computer to the default condition. When you install the software, the flash memory
data will be erased.
Back up important data to other media or an external hard disk before installation.
CAUTION
l Do not delete the Recovery Partition on the flash memory. The Recovery Partition is not available to store data.
To check the Recovery Partition, perform the following methods.
A Touch (Start) and long touch [Computer], then touch [Manage].
• A standard user needs to enter an administrator password.
B Touch [Disk Management].
NOTE
l You can use the following buttons instead of the keyboard.
: ↓ key
: ↑ key
: Enter key
: F2 key (Default setting)
l Connect the AC adaptor and do not remove it until installation is complete.
n Flash memory Recovery
You can reinstall the OS that was pre-installed at the time of purchase.
Preparation
l Remove all peripherals.
1 Turn on the computer, and touch the top left corner of the screen several times while
[Panasonic] boot screen is displayed.
The Setup Utility starts up.
l If the [Panasonic] boot screen is not displayed, turn on the computer while touching the top left corner of the
screen.
l If the password is requested, enter the Supervisor Password.
2 Write down all of the contents of the Setup Utility and touch [Exit] and double-touch
[Load Default Values].
At the confirmation message, touch [Yes].
3 Touch [Exit] and double-touch [Save Values and Reboot].
At the confirmation message, touch [Yes].
Computer will restart.
4 Touch the top left corner of the screen several times while [Panasonic] boot screen is
displayed.
The Setup Utility starts up.
l If the password is requested, enter the Supervisor Password.
5 Select the [Exit] menu, then double-touch [Recovery Partition].
6 Touch [Next].
7 Touch [Reinstall Windows.] and touch [Next].
The License Agreement screen appears.
8 Touch [Yes, I agree to the provisions above and wish to continue!] and touch [Next].
9 Touch [Next].
If the option is displayed, select the setting and touch [Next].
l [Reinstall Windows to the whole Disk to factory default.]
Select this option when you want to install Windows to the factory default. After installation, you can create a
new partition. For how to create a new partition, refer to "To change the partition structure" (è page 13).
l [Reinstall to the OS related partitions.]
Select this option when the flash memory has already been divided into several partitions. For how to create
a new partition, refer to "To change the partition structure" (è page 13).
You can keep the partition structure.
*1
This does not appear if Windows cannot be installed to the recovery partition and the area usable by Windows.
*1
19