Cable Diagram - FATEK FB Series Manual

5

Cable Diagram

The cable diagram shown below may differ from that recommended by the Fatek Automation Corporation. Please
be assured, however, that there is no operational problem in applying the cable diagram shown in this manual.
• The FG pin on the External Device must be D-class grounded. Refer to your External Device manual for
details.
• The SG and FG are connected inside the Display. If you connect the External Device to the SG, do not form
any short-circuit loop in the system design.
• If the communication is not stable because of noise or other factors, connect an isolation unit.
Cable Diagram 1
Display
(Connection Port)
GP3000 (COM1)
*1
GP4000 (COM1)
SP5000 (COM1/2)
ST (COM1)
LT3000 (COM1)
*2
IPC
PC/AT
GP-4105 (COM1)
*1 All GP4000 models except GP-4100 Series and GP-4203T
*2 Available only with a COM port that supports RS232C.
IPC COM Port (page 6)
1A)
1B)
Display side
Terminal block
Signal
name
Display
RD(RXD)
SD(TXD)
ER(DTR)
RS(RTS)
CS(CTS)
GP-Pro EX Device/PLC Connection Manual
1A FBs-232P0-9F-150 by Fatek Automation Corporation
1B
FBs-232P0-9F-150 by Fatek Automation Corporation
Display
FBs-232P0-9F-150
Shield
SG
User-created cable
Cable
User-created Cable
+
External Device side
D-sub 9 pin (plug)
Signal
Pin
name
2 RD(RXD)
3 SD(TXD)
4 ER(DTR)
5 SG
7 RS(RTS)
8 CS(CTS)
37
FB Series SIO Driver
Cable length:
15m or less
External Device
Mini DIN(plug)
FBs-232P0-9F-150
Remarks
-
External Device
Mini DIN(plug)