Velux KLI 311 Quick Setup Steps page 2

Setup of wall switch KLI 312 to operate
VELUX INTEGRA ® solar powered blinds DSL/RSL/FSL/FSC
If a non-functional wall switch must be replaced or if the wall switch cannot find certain products, the products can be
prepared for registration by resetting them manually.
Note: Reset products cannot be operated until they have been registered in the wall switch again.
Important: This only applies to KLI 312.
Depending on the blind, the RESET
1
button will be located as shown in
illustration or .
1A 1B
Press the RESET button on the
blind for 10 seconds (motor makes
a brief buzzing noise, but the prod-
uct does not move).
Note: Registration ( and
2
now be completed within the next
10 minutes.
Press PAIR button on the wall
2
switch for 1 second.
Press the STOP key and then the
3
DOWN key within 3 seconds.
The blind can now be operated with the wall switch.
4
NOTE: The motor must be adjusted to the size of the window before full
operation of the solar sunscreening product begins. This is done by running
the solar sunscreening product all the way up and down without interruption
using the wall switch.
ENGLISH
1A
) must
3
2
3
10 sec
max 3 sec
4
1B
10 sec
1 sec
VELUX ® 2