Solutions When "No Signal" Message Appears; Displaying From A Pc Laptop - Epson LS500W User Manual

Related references
Projector Light Status
Projector Setup Settings - Extended Menu
Input Signal Settings - Signal Menu
Projector Reset Options - Reset Menu

Solutions When "No Signal" Message Appears

If the "No Signal" message appears, try the following solutions:
• Press the
through the available sources. Wait a few seconds for an image to appear on each source you cycle
through.
• Press the
(shown in black text).
• Turn on the connected computer or video source, and press its play button to begin your presentation,
if necessary.
• Check the connection from the projector to your video sources.
• If you are projecting from a laptop computer, make sure it is set up to display on an external monitor.
• If necessary, turn the projector and the connected computer or video source off and then on again.
• If you are projecting from an HDMI source, replace the HDMI cable with a shorter one.
• Try a different video cable.
• If the other solutions do not solve the problem, reset all of the projector settings using the options on
the Reset menu.

Displaying From a PC Laptop

Displaying From a Mac Laptop
Parent topic:
Related concepts
Projector Connections
Related tasks
Selecting an Image Source
Displaying From a PC Laptop
If you see the "No Signal" message when you display from a PC laptop, you need to set up the laptop to
display on an external monitor.
Source button on the projector's control panel or remote control repeatedly to cycle
Home button on the projector's control panel to select from a list of available sources
Solving Image or Sound Problems
133