Epson LS500W User Manual page 130

On/Standby Status light
light
Flashing Varies
Off Flashing
Flashing Varies
Off Flashing
Laser light Temp light
Off Flashing
Off Solid
Flashing Off
Solid Off
130
Status and solution
Projector is too hot. If the temperature
continues to rise, projection will stop
automatically.
• Make sure that the vents and air
filter are not clogged with dust or
obstructed by nearby objects.
• Clean or replace the air filter.
• Make sure the environmental
temperature around the air intake
vents is not too hot.
Projector has overheated and turned
off. Leave it turned off to cool down
and wait about five minutes. After the
fan has stopped, disconnect the
power cord and do the following:
• Make sure that the vents and air
filter are not clogged with dust or
obstructed by nearby objects.
• Make sure the environmental
temperature around the air intake
vents is not too hot.
• Clean or replace the air filter.
• If operating the projector at high
altitude, turn on High Altitude
Mode.
• If the problem persists, unplug the
projector and contact Epson for
help.
Laser warning. Turn the projector off,
unplug it, and contact Epson for help.
Laser has a problem. Turn the
projector off, unplug it, and contact
Epson for help.