Nimbus Water Systems Sierra Manual page 7

Push Handle Airgap Faucet
1. Locate the faucet parts bag and arrange the parts on the
countertop in the sequence shown.
2. The last part in the sequence, the quick connect adapter
(6), will be found in the smaller parts bag.
3. Pull the white, yellow and blue tubing up through the faucet
hole in the sink.
4. Insert polished faucet base and rubber seal onto base of
faucet.
5. Push the 1/4" yellow drain tubing onto the 1/4" barb fi tting.
This tube must be of suffi cient length to reach the yellow drain
connection on the manifold.
6. Push the white 3/8" tubing onto the larger 3/8" barbed fi tting,
being sure you have enough tubing to reach the drain saddle.
7. Slide white plastic spacer open-end-up onto the threaded
faucet stem (2). Note: This spacer may be omitted it faucet is
installed in a granite countertop (or countertop with similar
thickness).
8. Thread the 3/8" washer (3), serrated washer (4) and mount-
ing lock nut (5) onto the threaded stem.
9. Thread faucet quick-connect adapter (6) on to threads of
faucet stem. NOTE: This connection should be hand-tightened
only. Push one end of 3/8" blue tubing into 3/8" connection.
10. Insert tubing and faucet assembly down through the sink
hole.
11. Position the faucet to the desired handle orientation. Slip
the slotted washer (1) between the white plastic spacer and the
sink. Securely tighten the mounting nut.
12. Connect the white 3/8" tubing to the drain saddle assem-
bly using the drain connector nut supplied. This tubing should
follow as direct a path as possible; long runs, looping or deep
sags will restrict normal brine fl ow to the drain. Save the
unused portion of the tubing for the installation of the storage
tank.
10. Firmly insert spout assembly into the top hole of faucet body
(approximately 1/4"). You may swivel the faucet left or right.
41840-A McAlby Court, Murrieta, CA 92562
(800) 451-9343, www.nimbuswater.com
Faucet to drain saddle
(3/8" white tubing)
Metal base plate
Rubber seal
1
2
3
4
5
6
System to airgap drain
(1/4" yellow tubing)
Product water
(3/8" blue tubing)
7