Cartridge Replacement - Nimbus Water Systems Sierra Manual

9

Cartridge Replacement

1. Close the feed water shut-off valve.
2. Close the tank shut-off valve.
3. Open the dispensing faucet to relieve system pressure. Close dispensing faucet when fl ow has stopped.
4. Pull the unit from the installed location.
5. Remove the retaining clip from the front of the unit. Pull the cartridge off the unit evenly at top and bottom.
Dispose of used cartridge.
6. Install the new cartridge, rocking gently from side to side as necessary until the cartridge tubes are properly
engaged in the unit connectors. Install the retaining clip, ensuring the slide locks snap into place in the slots. If
the clip does not snap easily into place through the slots it means the cartridge is not fully inserted into the con-
nectors. Press the top or bottom of the cartridge to engage the connector so that it snaps fully into place.
7. Repeat Steps 5 and 6 for each cartridge to be replaced.
8. Turn on feed water shut-off valve and open dispensing faucet.
9. Close dispensing faucet after water starts running.
10. Observe system for any leaks, especially at newly re placed cartridge.
11. Open the tank shut-off valve.
12. If replaced cartridge was a post carbon or a membrane fi lter, the system should be fl ushed at least once as
described in the previous section - Activation and Flushing.
41840-A McAlby Court, Murrieta, CA 92562
11
(800) 451-9343, www.nimbuswater.com