Table of Contents
Advertisement
REPAIR PROCEDURE
ssi2008-003-004_a
BAD GREASE APPLICATION
1. Oil hole
5. Install supercharger ass'y on PTO housing.
6. Apply Loctite 243 (blue — threadlocker) on the
retaining screws.
7. Torque screws to specification.
TIGHTENING TORQUE
Supercharger retaining
screws
8. To tighten and torque the upper screw, use the
Torx adapter.
REQUIRED TOOL
TORX ADAPTER (P/N 529
035 938)
9. Ensure to install the tool perpendicularly (90°) to
torque wrench to apply the proper torque to the
screw.
A
1
F00B1UA
1. Tool perpendicular (90°) to torque wrench
A. 90º
Not installing the tool as shown
CAUTION
will change the torque applied to the screw.
Proper torque and tightening sequence are
important.
8 / 8
9 N•m (80 lbf•in)
Instruction Sheet P/N 296 000 353
10. When reinstalling exhaust system compo-
nents,
validate LH muffler/exhaust pipe
alignment with exhaust manifold. Refer to
SEA-DOO SHOP MANUAL
appropriate
the procedure.
Recommended Engine Oil
Use
XPS 4-STROKE SYNTH. BLEND OIL (SUMMER)
.
(P/N 293 600 121)
If the recommended XPS
able, use a 10W40 mineral engine oil compatible
with wet clutches.
The XPS engine oil has been thoroughly
NOTE:
tested to be free of any additives that could impair
the functionality of the supercharger clutch.
NOTICE
NEVER use synthetic oil. This would
impair the proper operation of the super-
charger clutch. Do not add any additives to
the recommended oil. Mineral oils not recom-
mended by BRP may also contain additives
(friction modifiers) that may cause inappropri-
ate slippage of the supercharger and eventu-
ally lead to premature wear. For this reason,
XPS Synthetic Blend Summer Grade oil or a
BRP approved equivalent are the only recom-
mended oils. Use of any oil not recommended
by BRP may void BRP's limited warranty.
for
TM
engine oil is not avail-
Advertisement
Table of Contents
