Table of Contents
Advertisement
2. Set the wrench at 14 N•m (124 lbf•in).
– The clutch must slip before the wrench
clicks.
Supercharger Installation
1. Replace the two O-rings of the supercharger
ground plate with new O-rings [P9] from the kit.
ssi2005-008-007_b
2. Install three washers [P20].
Install washers only if the baseplate
NOTE:
part number 867 163 is found on MY 2003
or MY 2004 engines. The Baseplate 867 164
has the correct dimensions without using the
washers.
ssi2004-003-001_a
3. Ensure the three washers are in place (when
required) by visual and/or physical inspection.
Some Loctite 495 (General Purpose Instant
NOTE:
Adhesive) (P/N 293 800 021) can be applied on the
spacers to hold them in place.
Instruction Sheet P/N 296 000 353
4. Sealing surface between supercharger and
PTO housing [1] has to be greased with Super
Lube Grease (P/N 293 550 030).
1
R1503motr247A
Do not cover the oil hole of the
CAUTION
supercharger by applying too much grease
(Super Lube). Refer to the following illustra-
tions for details.
ssi2008-003-003_a
GOOD GREASE APPLICATION
1. Oil hole
REPAIR PROCEDURE
7 / 8
Advertisement
Table of Contents
