Wine Guardian CS025 Quick Start Installation Manual page 4

3.
Installing Thermostat (Wired)
A. Unit is supplied with 50 feet (15 meters) of cable with RJ-9
type connection to the Remote User Interface Controller.
B. Disconnect wire from back of controller and route the cable
to the desired mounting location within the room.
C. Locate Remote User Interface within the room midpoint on
a wall in an area with good airflow and away from any win-
dows or heat sources.
D. Remove back plate of controller and mark mounting points
at desired location.
E. Drill two 1/8" (3 mm) holes and insert anchors within mount-
ing surface. Anchors may not be required if securing to wall
studs or racking. Insert screws into the anchors and test fit
the installation of the backing plate tighten/loosen screws to
create a snug fit.
F. Provide 3/4" (19 mm) diameter hole within wall or racking
structure to provide clearance for RJ-9 connection at the
back of the controller.
G. Re-attach front cover plate by screwing it into place on the
back plate.
H. Connect RJ-9 cable to the back of the remote user interface
and attach to the wall at the screw locations
I. Reconnect cable to side of Wine Guardian unit at either
COM1 or COM2.
Note: For Wireless Installations see the
Version Manual
4.
Condensate Drain
A. Wine Guardian ceiling systems come equipped with a con-
densate pump system. Connect the drain line to the barbed
fitting at the unit and run the drain line to the nearest drain
location.
5.
Installing the Condensing Unit
A. Wine Guardian condensing unit must be mounted horizontally
on its base as shown and be level to +/- ¼" end to end and
1/8" side to side.
B. A minimum of 12 inches is required around the perimeter of
the condensing unit for proper airflow across the unit and for
service access.
starting on Page 51
4
Full