Cranesmart Systems LMI System User Manual page 4

Important Safety Information
All of Cranesmart™ Systems‟ load cells and support hardware have been designed and tested to have a minimum 5 to 1
safety factor and to meet or exceed the guidelines, standards and certification requirements set forth by more than 30
legislative bodies world-wide including API, ABS, DNV, ASME and OSHA.
All Cranesmart™ load cells and support hardware are to be considered "Critical Path"components. Loads imposed on
these components should never exceed the maximum rated capacity shown on the load cell(s)/components. The rated
capacity applies only to uniform direct tension loading (straight-line pull). Off-axis loading, bending, side loading, two-
blocking and shock loads should be avoided. Damages caused by such situations are not covered by our warranty.
Inspection for damage, deterioration, cracks and corrosion on all load-bearing components should be conducted pre-
use, weekly, monthly, quarterly or annually, depending upon crane usage. Load bearing components showing damage,
deterioration, cracks or corrosion should be removed from service. If the crane is two-blocked or side loaded the load
cell and links should be visually inspected immediately. Continued use of damaged components may result in
catastrophic failure and personal injury.
Unless authorized by the factory in writing, modifications such as cutting, welding or permanently attaching other
material to any load cell, pin, link or part-thereof will void the warranty. Do not repair, alter, rework, or reshape any load
bearing component by welding, heating, grinding or bending. Do not engrave or stamp markings into the steel body of
the load cell as this may affect the integrity of the load cell, will void the warranty, and may result in a costly replacement
of the steel body.
Regular Inspections
We recommend that all load components regularly undergo routine visual inspection as noted above. We also
recommend that a qualified inspector, using industry standard techniques such as Ultrasonic Testing and/or Dye
Penetrate Testing, annually inspect the load components. These tests are to be performed in conjunction with the
inspection frequencies and guidelines as mandated by your applicable regulatory bodies.
IMPORTANT NOTE: Do not disassemble the load cell by removing the plastic covers during testing. Disassembly will
require the cell to be returned to the factory for re-calibration and testing.
If ANY issues are found please note the Cranesmart™ System serial number, contact our staff at 888-562-3222 or 780-
437-2986 and ask for the service department.
3 Cranesmart LMI Version R9